channel group 1 mode desirable
channel group 1 mode desirable

desirablemeanstryandnegotiatewiththeotherside,andifheagrees,thenenablethechannel.Ifyouhaveonononesideand ...,2009年10月1日—Switch(config-if)#channel-group10mode?activeEnableLACPunconditionallyautoEnablePAgPonlyifaPAgPdeviceisdetecteddesirableEnab...

Exam 350

2021年4月7日—TheanswerisCbecauseSW2isrunningPAgP(CiscoProprietary).channel-group1modedesirableenablesPAgP.channel-group1modeactive ...

** 本站引用參考文章部分資訊,基於少量部分引用原則,為了避免造成過多外部連結,保留參考來源資訊而不直接連結,也請見諒 **

Channel

desirable means try and negotiate with the other side, and if he agrees, then enable the channel. If you have on on one side and ...

channel

2009年10月1日 — Switch(config-if)#channel-group 10 mode ? active Enable LACP unconditionally auto Enable PAgP only if a PAgP device is detected desirable Enable ...

EtherChannel Modes

2020年9月9日 — A port in the desirable mode can form an EtherChannel with another port that is in the desirable or auto mode. A port in the auto mode can form ...

Etherchannel on Cisco IOS Catalyst Switch

... EtherChannel only have the channel-group command: SW1#show run interface GigabitEthernet 0/1 interface GigabitEthernet0/1 channel-group 1 mode desirable end

EtherChannel PAgP LACP 以太通道

設定方法亦不難,只要用channel-group 1 mode desirable 來設Desirable Mode 和用channel-group 1 mode auto 來設Auto Mode 即可。 etherchannel. SW1(config)# ...

EtherChannel PAgP LACP 以太通道

设定方法亦不难,只要用channel-group 1 mode desirable 来设Desirable Mode 和用channel-group 1 mode auto 来设Auto Mode 即可。 etherchannel. SW1(config)# ...

EtherChannel 設定

2021年3月14日 — PAgP desirable: In this mode, PAgP negotiations with other interfaces by sending PAgP packets. PAgP auto: In a passive negotiating state,. LACP:.

Exam 350

2021年4月7日 — The answer is C because SW2 is running PAgP (Cisco Proprietary). channel-group 1 mode desirable enables PAgP. channel-group 1 mode active ...

What is Etherchannel ?

2023年4月15日 — EtherChannel works by grouping ... S1(config)# interface fa0/1 S1(config-if)# channel ... Here, the user has used the mode desirable and switch-port ...

端口聚合channel

端口聚合channel-group 1 mode desirable ... Command rejected: An interface whose trunk encapsulation is Auto can not be configured to trunk mode.


channelgroup1modedesirable

desirablemeanstryandnegotiatewiththeotherside,andifheagrees,thenenablethechannel.Ifyouhaveonononesideand ...,2009年10月1日—Switch(config-if)#channel-group10mode?activeEnableLACPunconditionallyautoEnablePAgPonlyifaPAgPdeviceisdetecteddesirableEnable ...,2020年9月9日—AportinthedesirablemodecanformanEtherChannelwithanotherportthatisinthedesirableorautomode.Aportintheautomodecanform ...,...EtherCh...